Albany UltraFabric Manuel d'utilisateur télécharger pdf (Page 8)

7 Manual #001011 Rev. 4/29/2010

Periodic Maintenance

Albany Door Systems high speed doors are engineered for low maintenance operation. The door

should be visually inspected daily for wear and tear, and operated to verify functions. Quarterly

maintenance should be performed to clean components and to check all safety functions and check

for mechanical and electrical integrity.

Daily Inspection

1. Inspect the door fabric for wear or damage.

2. Operate the door through several openings and closings. Verify that the door seats against the

floor and that the door fabric remains tight and does not wrinkle. Verify that the door opens fully,

slightly beyond the wall opening, and does not open too far.

If the door does not seat against the floor properly or opens to the wrong position, refer to

“Setting Door Limit Adjustments”.

If the door fabric has diagonal wrinkles the door fabric roll at the top of the door is not level

and perpendicular to the side rails. Leveling adjustments should be made as soon as pos-

sible to prevent wear or damage. Refer to the installation instructions or contact Albany

Door Systems.

3. With the door closing, place an object through the light curtain, or photoeyes, on each side of the

door. Verify that the door stops immediately.

4. If a multiple panel door is installed, check at each end of the ribs to verify that they are in place

and centered.

5. Inspect the coiled electrical wire for wear or damage.

6. Check the light curtain slots for dirt or dust accumulation and clean as necessary.

7. While the door is closing, tap the bottom of the door edge wand verify that the door stops and re-

verses to a fully open position.

Do not stand under the door when performing the following inspection. If the bottom bar re-

versing switch is not functioning correctly injury can occur.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Pas de commentaire

Albany UltraFabric Manuel d'utilisateur Page 8